Bopp Tape Manufacturing Machine Cost
make clear & color & printed big jumbo roll from bopp film and glue on same machine by one step.
Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine
Auxiliary accessories for the tape machine:
6. Check whether there are any omissions in the installation, ensure the installation of the heater, the heat sensor, and the drive train; check whether the circuits are connected correctly, and the wires are not leaking; whether the whole body is offset incorrectly, and the oven has a gap.
7. After the installation is correct, start the test machine one by one. If there is any abnormality, stop the machine immediately and check the adjustment; after confirming the completion, start the production again (pay attention to personal safety and machine safety during the operation). The tape machine constitutes an important part of its function:
Unwinding device - responsible for the discharge and winding of the parent roll, can be equipped with tension control.
Printed section - configurable for monochrome, two-color printing.
The sizing part consists of a topping roll and a squeegee roll for applying glue to the substrate. Oven part - dry the glue.
Slitting section - the substrate after the coating is cut as needed.
Winding part - Winding the tape after slitting, you can determine the length of the winding as needed, or you can collect large rolls.
Transmission section - sub-chain drive and gearbox drive. The average speed of the chain drive is equal, but there is an instantaneous speed, which is not suitable for services with high precision. Slitting machine - slitting the tape machine
Pipe puller - unloading and loading the paper tube on the take-up reel by hydraulic pressure
Automatic pipe cutting machine - slitting the paper tube
Rewinding machine - finishing some of the tape defective products (especially the untidy winding) to reduce the defective rate.
Tape factory budget cost --
Printing patterns and text on the sealing tape not only increases the value of the tape, but also gives the tape a certain advertising function. When printing, it is necessary to pay attention to selecting the appropriate ink. Improper ink will affect the coating effect of the pressure sensitive adhesive. Something will lead to the adhesion of the pressure sensitive adhesive at the pattern, and the rubber transfer phenomenon occurs during unwinding.
2. Coating and drying
Coating is the most important process for making sealing tape. The pressure sensitive adhesive is applied to the BOPP film and then dried by an oven.
3. Slitting and winding
Cut the parent roll into the size that the user needs, and then curl it. This process should pay attention to keep the sharpness of the slitting knife, otherwise the edge of the tape will be uneven, which will cause the tape to be easily torn when it is wound.
According to the size of the tape machine, it is 9.6 meters long, 2.2 meters wide and 2.2 meters high. The required workshop area is 25 × 10 = 250 square meters. The office area needs 10×10=100 square meters, and the total plant area is 250+100=350 square meters.