Bopp Tape Manufacturing Machinery
1.1. Used to produce BOPP packing tape;
1.2. Suitable material:
1.2.1. Base material: BOPP film (0.023-0.032mm) ;
1.2.2. Glue: acrylic acid glue, solid content no less than 55%, viscosity: 150~200CPS.
Sealing tape characteristics --
Compression fixation: The product is wrapped and wrapped by the retractive force of the stretched film to form a compact, space-saving unit, so that the trays of the product are tightly wrapped together, which can effectively prevent the products during transportation. The mutual misalignment and movement, while the adjustable tensile force can make the hard product close to each other, making the soft product tight, especially in the tobacco industry and the textile industry.
Cost-saving: The product packaging can be effectively reduced by using the wrapping film. The winding film is only about 15% of the original box packaging, about 35% of the heat shrinkable film, and about 50% of the carton packaging. At the same time, it can reduce the labor intensity of workers, improve packaging efficiency and packaging grade.
Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine
Auxiliary accessories for the tape machine:
6. Check whether there are any omissions in the installation, ensure the installation of the heater, the heat sensor, and the drive train; check whether the circuits are connected correctly, and the wires are not leaking; whether the whole body is offset incorrectly, and the oven has a gap.
7. After the installation is correct, start the test machine one by one. If there is any abnormality, stop the machine immediately and check the adjustment; after confirming the completion, start the production again (pay attention to personal safety and machine safety during the operation). The tape machine constitutes an important part of its function:
Unwinding device - responsible for the discharge and winding of the parent roll, can be equipped with tension control.
Printed section - configurable for monochrome, two-color printing.
The sizing part consists of a topping roll and a squeegee roll for applying glue to the substrate. Oven part - dry the glue.
Slitting section - the substrate after the coating is cut as needed.
Winding part - Winding the tape after slitting, you can determine the length of the winding as needed, or you can collect large rolls.
Transmission section - sub-chain drive and gearbox drive. The average speed of the chain drive is equal, but there is an instantaneous speed, which is not suitable for services with high precision. Slitting machine - slitting the tape machine
Pipe puller - unloading and loading the paper tube on the take-up reel by hydraulic pressure
Automatic pipe cutting machine - slitting the paper tube
Rewinding machine - finishing some of the tape defective products (especially the untidy winding) to reduce the defective rate.