Cloth Tape Cutting Machine

Cloth Tape Cutting Machine

Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.

Cloth Tape Cutting Machine

Instructions for the operation of the tape cutter.
The tape cutter is operated differently than the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut.
If the cut tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be put into the tape cutting machine, the tape head should be pulled, then the power is turned on, and the switch is turned on.
Set according to the requirements, press the yellow button (start button) on the right after setting, the tape cutting machine starts to run and cut. The tape cutter cuts only a piece of tape at a time, and spits the cut tape out at the gate.
The sensor is installed at the gate. If the tape is not removed, the tape cutter will remain in a stagnant state. When we remove the tape, the tape cutter will automatically start and cut the next tape. Cycle back and forth.

Cloth Tape Cutting Machine

Tape Cutting Machine Features:
 

1. Easy Operation,It can cut automaticlly once set up the cutting length and quantity.

2.Self protection Function,It will stop automaticlly if the materials run out during the operation.

3.High speed,it can cut 100-120pcs per minute(50mm length for example)

4.High Accuracy,the cutting length is accurate cwing to a stepping motor.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com