Sealing Carton Tape Making Machine
It is mainly used for proucing kinds of medical tape which are coating zinc oxde hot melt pressure sensitive adheive on silicon paper/glassine paper/ginning membrance, then laminate with cartoon PE/spun-laced non-woven fabric/cotton. or coat adhesive on kinds of substrate directly.
Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine
Tape dispenser installation www.easttapemachine.com
1. The site for site selection and installation of the tape conveyor must be on a relatively flat hardened floor. Because the tape machine needs a good environment for operation, it cannot be said that the ground is pitted and the various parts of the operation are uncoordinated to produce the product. Not qualified! This is all that needs to be considered.
2, the machine is assembled, the tape machine is generally separated from each other. Before the installation is completed, after the site is selected, the front and rear intermediate frames are placed on the level ground to maintain a uniform horizontal line! To maintain stable operation.
3. After the installation is completed, pre-work processing is performed on each part of the machine, including chain, sprocket, bearing, reducer, lubricating oil or grease.
4. After the lubrication treatment, the main components are debugged to keep them rotating smoothly, and no blockage can occur.
5. After the installation of each part is completed, turn on the power to test the machine! No need to install materials during the test machine, and do a bare test! Observe the operation of each component! Found an abnormality, power-off treatment,
6. When the tape machine is not running, the power must be disconnected for safety.
Tape factory budget cost --
Printing patterns and text on the sealing tape not only increases the value of the tape, but also gives the tape a certain advertising function. When printing, it is necessary to pay attention to selecting the appropriate ink. Improper ink will affect the coating effect of the pressure sensitive adhesive. Something will lead to the adhesion of the pressure sensitive adhesive at the pattern, and the rubber transfer phenomenon occurs during unwinding.
2. Coating and drying
Coating is the most important process for making sealing tape. The pressure sensitive adhesive is applied to the BOPP film and then dried by an oven.
3. Slitting and winding
Cut the parent roll into the size that the user needs, and then curl it. This process should pay attention to keep the sharpness of the slitting knife, otherwise the edge of the tape will be uneven, which will cause the tape to be easily torn when it is wound.
According to the size of the tape machine, it is 9.6 meters long, 2.2 meters wide and 2.2 meters high. The required workshop area is 25 × 10 = 250 square meters. The office area needs 10×10=100 square meters, and the total plant area is 250+100=350 square meters.