Duct Tape Cutting Machine

Duct Tape Cutting Machine

Tape Cutting Machine-

Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.

Duct Tape Cutting Machine

Tape Cutting Machine- working principle
The tape cutting machine is also called a tape cutter. The tape is cut by the upper and lower blades, and the length is set according to the length of the customer's demand. 
The tape cutter has a sensor, and after the tape cutter cuts the tape,The tape will fall over the sensor. If the tape is removed, the sensor will automatically sense that there is 
no tape and immediately send a signal, and the tape will automatically perform the next cutting action. This kind of action is repeated continuously, that is, automatic continuous cutting.
Yuanxiao tape cutting machine mainly has automatic tape cutting machine and manual tape cutting machine. Now it has a wide range of automatic application. Manual cutter is mainly used for tape sealing. 
Automatic tape cutters are used in the electronics industry, wire harness industry.

Duct Tape Cutting Machine

Instructions for the operation of the tape cutter.
The tape cutter is operated differently than the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut.
If the cut tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be put into the tape cutting machine, the tape head should be pulled, then the power is turned on, and the switch is turned on.
Set according to the requirements, press the yellow button (start button) on the right after setting, the tape cutting machine starts to run and cut. The tape cutter cuts only a piece of tape at a time, and spits the cut tape out at the gate.
The sensor is installed at the gate. If the tape is not removed, the tape cutter will remain in a stagnant state. When we remove the tape, the tape cutter will automatically start and cut the next tape. Cycle back and forth.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com