Opp Adhesive Tape Machine

Opp Adhesive Tape Machine

Make adhesive tapes from raw material to different sizes of small clear & color & printed tapes and jumbo roll on same machine by one step.

Opp Adhesive Tape Machine

Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine

Tape dispenser installation www.easttapemachine.com
1. The site for site selection and installation of the tape conveyor must be on a relatively flat hardened floor. Because the tape machine needs a good environment for operation, it cannot be said that the ground is pitted and the various parts of the operation are uncoordinated to produce the product. Not qualified! This is all that needs to be considered.
2, the machine is assembled, the tape machine is generally separated from each other. Before the installation is completed, after the site is selected, the front and rear intermediate frames are placed on the level ground to maintain a uniform horizontal line! To maintain stable operation.
3. After the installation is completed, pre-work processing is performed on each part of the machine, including chain, sprocket, bearing, reducer, lubricating oil or grease.
4. After the lubrication treatment, the main components are debugged to keep them rotating smoothly, and no blockage can occur.
5. After the installation of each part is completed, turn on the power to test the machine! No need to install materials during the test machine, and do a bare test! Observe the operation of each component! Found an abnormality, power-off treatment,
6. When the tape machine is not running, the power must be disconnected for safety.

Opp Adhesive Tape Machine

Introduction of four-axis winding new tape machine -- GL- X multi-function tape machine

Auxiliary accessories for the tape machine:

    6. Check whether there are any omissions in the installation, ensure the installation of the heater, the heat sensor, and the drive train; check whether the circuits are connected correctly, and the wires are not leaking; whether the whole body is offset incorrectly, and the oven has a gap.
    7. After the installation is correct, start the test machine one by one. If there is any abnormality, stop the machine immediately and check the adjustment; after confirming the completion, start the production again (pay attention to personal safety and machine safety during the operation). The tape machine constitutes an important part of its function:
Unwinding device - responsible for the discharge and winding of the parent roll, can be equipped with tension control.
Printed section - configurable for monochrome, two-color printing.
The sizing part consists of a topping roll and a squeegee roll for applying glue to the substrate. Oven part - dry the glue.
Slitting section - the substrate after the coating is cut as needed.
Winding part - Winding the tape after slitting, you can determine the length of the winding as needed, or you can collect large rolls.
    Transmission section - sub-chain drive and gearbox drive. The average speed of the chain drive is equal, but there is an instantaneous speed, which is not suitable for services with high precision. Slitting machine - slitting the tape machine
Pipe puller - unloading and loading the paper tube on the take-up reel by hydraulic pressure
Automatic pipe cutting machine - slitting the paper tube
Rewinding machine - finishing some of the tape defective products (especially the untidy winding) to reduce the defective rate.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com