Cutting Tape Machine

Cutting Tape Machine

Tape Cutting Machine-

Second, preparation before use:
1. Check the external power supply is correct.
2. Check that the workpiece ground wire is clamped on the workpiece.
3. Turn on the air source and drain the water.
4. Check that the power switch is in the off position.
5. Close the main switch of the power supply of the power grid. At this time, the fan starts to work. Pay attention to check the wind direction. The wind should blow inward. Otherwise, the main transformer will not be ventilated and cooled, which will shorten the working time.
6. Turn the power switch on the panel to the “on” position and the power indicator light. Compressed air should flow out of the torch at this point. Pay attention to whether the pressure gauge pressure gauge pointer is 0.2-0.4 megabytes
Pa position, if the pressure does not match, in the case of gas flow, adjust the upper knob of the filter pressure reducing valve pressure gauge, clockwise to increase pressure, and vice versa.
7. Let the gas flow for a few minutes to remove the condensed water vapor from the torch.

Cutting Tape Machine

Tape Cutting Machine features:
1. The tape cutting machine adopts no roller design, which is convenient for operation.
2, the maximum width of the cutting is 60mm (see machine parameters below), this must be understood before use, to see if it meets the width of the tape you want to cut.
3, the tape cutting machine with memory function, according to the length of the tape cut usually from the set of six different cutting lengths, you can call directly after the need to set up.
4, install the tape, through the elastic film auxiliary shaft, so it is easier to fix the film to prevent the tape roll from falling.
5, tape cutting machine with counting function, you can set the amount to be cut.
6. Two rolls of tape can be used at the same time, but the total width should be within the width parameter of the tape cutter.
7. Be careful when taking the tape. Although the tape cutter is equipped with a protective device and a safety guard at the knife edge, try not to approach the knife edge.
8, accurate digital control cutting length, you can set the length you want to cut.
9. It is not necessary to adjust the tape cutter because of the thickness of the tape.
10. The tape cutting machine has built-in pliers, lubricating oil and partition for easy operation.
11, anti-static ABS material

Cutting Tape Machine

Tape Cutting Machine Features:
 

1. Easy Operation,It can cut automaticlly once set up the cutting length and quantity.

2.Self protection Function,It will stop automaticlly if the materials run out during the operation.

3.High speed,it can cut 100-120pcs per minute(50mm length for example)

4.High Accuracy,the cutting length is accurate cwing to a stepping motor.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com