Inspection and preparation before the cutting machine is turned on
4.1.1. Confirm that the main power supply voltage is 380V.
4.1.2. Turn on each power switch and check if the electricity and gas supply are normal.
4.1.3. Before starting the machine, you must confirm that the surface of each guide roller is smooth and free of burr dust, debris, etc. When cleaning the machine, use alcohol or water to soft cloth.
Wipe, can not be wiped with other solvents, remove the impurities around the equipment and production, to ensure normal production;
4.1.4. Obtain all kinds of accessories and tools such as slitting products and tapes in strict accordance with the production instruction sheet and the process card requirements.
184.108.40.206. Receive the composite film specified on the production instruction sheet, check whether the composite film tracking card is complete, and describe the previous quality problem is it clear.
220.127.116.11. Confirm the cut specifications, roll direction, batch number, material structure, winding diameter or meter number according to the production order. 4.1.5. Carefully check the equipment to confirm that each rewinding mechanism, EPC device, and tension control system are normal, and confirm static electricity.
Whether the elimination is normal or not;
4.1.6. The unwinding material is ready, and then the film is routed in the correct way;
4.1.7. Prepare the winding paper core according to the slitting specifications and place it in the corresponding position of the winding reel.
Daily maintenance and maintenance of the slitter:
First, the electrical parts should be cleaned and inspected regularly to remove hidden dangers in time.
Second, the use of slitting machines is done by slitting machines and cross-cutting machines. Therefore, high-quality slitting cutters and cross-cutting cutters are used.
Third, the daily maintenance of the slitting machine should be in place. The standard is that smooth, clean, clear (no dust, no debris) is in place to ensure that the sliding part of the equipment is in good condition.
Fourth, it is the maintenance work, and the regular and irregular inspections of the rotating parts should be stopped (especially the real-time monitoring of the wearing parts should be stopped). Regular adjustments are made, regular changes are made, commutators are carefully recorded, and the purpose of extending the service life of the equipment is achieved.
Fifth, improve the technical quality and degree of the personnel who operate the slitting machine. The control of the local operation must be done by a special person, and no one can operate it without any permission.
Tape slitting machine feeding, filming and filming
1. Loading: According to the requirements of the cutting plan, according to the driving operation rules, according to the actual situation, hoist the corresponding mother roll on the aging frame, place it on the unwinding unwinding frame according to the inner and outer selection direction of the corona surface, and use the control button Clamp the steel core, leave the steel core support arm and drive.
2. Film penetration: When there is no film on the slitter, the film must be penetrated. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.
3. Film: When there is a film on the slitter, when changing the joint, use the vacuum filming table to start the filming station to the working position, manually flatten the film on the first pulling roller of the slitting machine and start the upper vacuum pumping film. Soak the film flat on the filming table, attach the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to make the film flat and absorb the paper. Layer and flatten the adhesive film, the joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps to open the filming station to the inoperative position.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc