Slitting Machine Rewinding

Slitting Machine Rewinding

Preparation of slitter cutter
1. Razor slitting
1.1. The razor slitting requires the film to travel in the correct direction to the winding section.
1.2. Adjust the photoelectric tracking to bring the film to the proper position.
1.3. Tension the film and attach the blade to the razor holder.
1.4. According to the specifications required by the instruction sheet, the sliding razor holder is cut into the razor groove under the film, and the blade edge and the edge of the sipe are required to be in contact with each other.
1.5 After adjusting the depth of the cutter, lock the razor frame screws.
2. Round knife cutting
2.1. Check whether the upper and lower knives are sharp and have no gaps, and vice versa;
2.2. Determine the number of knives (N+1) according to the number of product series (N);
2.3. Install the lower knife to adjust the width of the lower knife according to the actual width of the product;
2.4 Install the upper knife correctly. The flat side of the upper knife is aligned with the side of the lower cutting edge. The upper knife is aligned with the gap between the lower knife and the septum. Press the screws on both sides to make the upper knife enter the gap depth to about 2mm. The upper knife is attached to the lower knife and fastened. Finally, the screw on the left side of the upper knife holder is adjusted so that the whole knife holder moves 1-2 mm to the right side and is fastened.

Slitting Machine Rewinding

Slitting machine shutdown operation
1. After the cutting is completed, the unloading is stopped;
2. Release the switch and lift the cutter unit.
3. Clean the crimping device and turn off the curling blower.
4. Turn off the photoelectric tracking system.
5. Turn off the power and air supply of the whole machine.
6. Clean up the surrounding environment.
7. Carefully fill in the production daily record, product self-checklist and other work records.

Slitting Machine Rewinding

Tape slitting machine feeding, filming and filming
1. Loading: According to the requirements of the cutting plan, according to the driving operation rules, according to the actual situation, hoist the corresponding mother roll on the aging frame, place it on the unwinding unwinding frame according to the inner and outer selection direction of the corona surface, and use the control button Clamp the steel core, leave the steel core support arm and drive.
2. Film penetration: When there is no film on the slitter, the film must be penetrated. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.
3. Film: When there is a film on the slitter, when changing the joint, use the vacuum filming table to start the filming station to the working position, manually flatten the film on the first pulling roller of the slitting machine and start the upper vacuum pumping film. Soak the film flat on the filming table, attach the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to make the film flat and absorb the paper. Layer and flatten the adhesive film, the joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps to open the filming station to the inoperative position.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com