Slitting Machine Pvc

Slitting Machine Pvc

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Slitting Machine Pvc

Daily maintenance and maintenance of the slitter:
First, the electrical parts should be cleaned and inspected regularly to remove hidden dangers in time.
Second, the use of slitting machines is done by slitting machines and cross-cutting machines. Therefore, high-quality slitting cutters and cross-cutting cutters are used.
   Third, the daily maintenance of the slitting machine should be in place. The standard is that smooth, clean, clear (no dust, no debris) is in place to ensure that the sliding part of the equipment is in good condition.
Fourth, it is the maintenance work, and the regular and irregular inspections of the rotating parts should be stopped (especially the real-time monitoring of the wearing parts should be stopped). Regular adjustments are made, regular changes are made, commutators are carefully recorded, and the purpose of extending the service life of the equipment is achieved.
Fifth, improve the technical quality and degree of the personnel who operate the slitting machine. The control of the local operation must be done by a special person, and no one can operate it without any permission.

Slitting Machine Pvc

Tape slitting machine principle:
1. The paper slitting machine shall carry out the fixed length slitting processing of the whole roll or the whole raw material, such as plastic packaging materials, packaging carton, steel plate, film, leather, wood chip, etc., and the fixed length slitting control shall be used.
2. The slitting length can be set continuously. If there is an error in the actual slitting length, it is easy to calibrate by setting parameters.
3. The slitting control of the paper slitter is divided into static and dynamic slitting: it stops accurately when the set length arrives, then static slitting processing, restarts after slitting; when the set length arrives, it does not stop. The slitting signal is dynamically slitted during the material movement process.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com