Bopp Coating Machinery

Bopp Coating Machinery


1. It is provided with anilox roller plus blade for coating mode, and also provided with many selection opportunities of anilox roller with various coating amount. 

2. It is provided with separate five-section type constant temperature drying system using infrared stainless steel heating tube plus beating wind, as wellas adjustable interior circulation air draining and suction devices. It is advantageous in strong wind-exit and wind entrance, helping drying thoroughly. 
 

Bopp Coating Machinery

The Adhesive Tape Coating Machine machine is suitable for the production of bronzing film, laser laser film, gold and silver cardboard, notice stickers and other coating composite products.
An anilox roll with a knife coating method is available, and a variety of coating rolls are available for selection.
Mobile knife device, pneumatic device.
Five sections of independent constant temperature semiconductor tube heating air drying system, adjustable internal circulation suction and exhaust device, strong wind and exhaust in the exhaust and exhaust.
The anilox roller and the traction roller are controlled by cylinder pressure. Automatic metering device.
The retractable shaft adopts a self-propelled air-expansion shaft and is convenient to handle loading and unloading. The whole oven is pressed with a gas top.
The whole machine three motors synchronously control the coating, drawing and winding.

Bopp Coating Machinery

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com